SUL 2.0 Down Sweater

The SUL (super ultralight) series garments are aimed at pushing weight as low as possible for a given fill amount, without compromising function. They are down sweaters in the strictest sense. Like a knit sweater, no zippers, no pockets, no linings, no webbing, just insulation in the form of down in a nylon shell. Now available with zippers and pockets.

Fill type – 900fp Hyperdry goose down

Fill weight (approximate) – Fill weight is not a reliable metric for warmth. See calculated loft.

Total weight (approximate) – 9.6oz (medium)

The SUL 1.5 has proven to be quite warm for mid-winter here in the NEUS (and in many, many other places!), but there is reason to push the line up a little further for folks who run extra cold, want extra luxurious warmth, or live in climates where the temps dip lower. The SUL 2.0 bumps the calculated loft up to 2 and widens the chambers to 7″. It has a cinch at the neck and a cinch at the bottom hem to keep out drafts. Both cords are removable. Like the SUL / SDUL 1.5, this has a lot of loft and one should plan on adding room for that loft in the fit. When in doubt, oversize. A snug and fitted puffy is cold. A loose fitting puffy is warmer and usually ends up covering more of your body.

A puffy is most often used as an inactive layer for stops, at camp, or to help boost a sleep system. They don’t make for very good active layers since your sweat can easily compromise the down fill. This makes a zipper for ventilation a somewhat frivolous feature that can add a significant amount of weight and bulk. Pockets can be nice to have, but they often add a big chunk of weight and bulk and compromise the performance of a jacket by creating cold spots and by pulling insulation flat when there is weight in them. For those wanting pockets to warm hands I recommend adding a few inches to the sleeve to cover your hands. This is lighter than pockets and doesn’t compromise the overall warmth. All non-essential sewn through lines have been eliminated so the down can loft and cold spots are reduced. Simplicity and reduced weight and bulk are not the only benefits of all this. Leaving off many tedious features also reduces my labor and allows me to offer a very affordable jacket at an extremely low weight.

It’s meant to be used with a modular hood or head insulation, but can be built with an integrated hood on request.

More warmth out of less fill Sewn Through Baffle Construction and Its Effect on Warmth – Timmermade

These are now available with zippers and pockets, but one should expect each of these to reduce the effectiveness of these garments. The zipper isn’t too bad, but it’ll increase the cold spot in front, and add a chunk of weight. The pockets will add two big cold spots on the sides and placing weight in them can cause shell tension and loft loss. The design of them is intended to limit this effect, by attaching the pocket to points that transfer load up to places that already have sewn through spots. However, it is inevitable that weight will still pull some loft flat. The wearer should be aware of this tendency to try to limit the weight placed on the shells. Storing light things and warming your hands with them supported by something other then the pocket will be less detrimental.